Step-1
Startup assembly

1. There are 5 to 6 parts for each foundation. Layout the side rails end rails and center support as seen in this image
2
Position rails with bolts

2. Attach one end rail to each of the siderails and center support by positioning the side rails and center support so that the bolts match up.
3
Tighten & secure the bolts

3. Use lock washers and wing nuts to tighten to lock siderails and center support to the end rails. Paying particular attention to the center rail. Once the center rail is in place the side rails can be maneuvered more easily to get all the rails into place.
4
Position top slats

4. Place the stack of top slates at one end of the foundation and align them with the Velcro strips.
5
Align slats with velcro

5. Place the stack of top slates at one end of the foundation and align them with the Velcro strips.
6
Position Quilted Cover

6. Place the stack of top slates at one end of the foundation and align them with the Velcro strips.
7
Pull cover over the corners

7. Place the felted quilted cover and secure and pull the corner down under the foundation.
8
Align Corner Velcro strips

8. Secure the cover with the Velcro strips attached to the corner and bottom side of the end and the side rails.
9

9. Place the felted quilted cover and secure with the Velcro pieces provided under the end and the side rails.
10
Assembled foundation

10. Fully assembled U.S. Box Spring KD foundation.